HammondWiki - Diff: StartMotor

Differences between current version and predecessor to the previous major change of StartMotor.

Other diffs: Previous Revision, Previous Author

Newer page: version 4 Last edited on March 21, 2005 12:32 pm. by
Older page: version 2 Last edited on February 12, 2003 9:44 am. by
@@ -1,7 +1,11 @@
 From '53 Hammond tech sheet 
  
 ;: A shaded pole induction motor is used for starting the ToneGenerator, and is located at the right-hand end of the ToneGenerator as viewed from the back. The rotor of this motor slides endwise when current is supplied and engages a pinion on its shaft with a gear on the driveshaft of the ToneGenerator, bringing the ToneGenerator up to slightly greater than SynchronousSpeed. 
  
-;:This motor has a resistor added in series at the application of the RunSwitch. The loss of power caused the system to fall to SynchronousSpeed with the SynchronousMotor carrying the load. 
+;:This motor has a resistor added in series at the application of the RunSwitch. The loss of power causes the system to fall to SynchronousSpeed with the SynchronousMotor carrying the load.  
+  
+It should be clear that the induction start motor is geared to turn faster than the synchronous speed of 1200RPM. When the run switch is turned on, the resistor drops the start motor speed closer to synchronous speed.  
+  
+This can be used as a special effect to off-speed the tone generator and "bend" the note. See SpecialEffects
  
 See also: [HowToStartAHammond] 

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.