Differences between version 4 and predecessor to the previous major change of LineOutToAHammondToneCabinet.

Other diffs: Previous Revision, Previous Author

Newer page: version 4 Last edited on April 3, 2005 12:45 pm. by
Older page: version 1 Last edited on October 11, 2002 8:06 am. by
@@ -5,11 +5,11 @@
 # Connect hot and ground of your signal output to either end of these "series-ed" resistors. (Do __not__ connect ground of your device to tone cabinet ground.) 
 # Connect these two ends of series-ed resistors with signal of your device connected to them to the G-G inputs (pins 1 and 6) of ToneCabinet. 
 # Where the resistors in series meet, make a connection from there to tone cabinet ground (pin 2.) 
 # The signal stength should be pretty high --- loudspeaker level or a little lower, and the lower the impedance of the source, the better. 
-# Tried and true, and, incidentally, the way the Hammond Company reccommended hooking up a Solovox to a Hammond Tone Cabinet in 1941. 
+# Tried and true, and, incidentally, the way the Hammond Company reccommended hooking up a [ Solovox] to a Hammond Tone Cabinet in 1941. 
 Voila. 
 ----------- 
  
 PS: If you're tapping off a speaker output and you disconnect whatever speaker you're tapping off of, dont forget to "replace" it with a properly rated resistor. 
 ----- 
 TopicHookup 

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.