Differences between version 6 and previous revision of HowToRebuildTheVibratoScanner.

Other diffs: Previous Major Revision, Previous Author

Newer page: version 6 Last edited on February 26, 2009 10:38 am. by
Older page: version 5 Last edited on January 27, 2009 9:14 am. by
@@ -45,16 +45,18 @@
 Make sure you clearly mark where the red & blue wires go. Do not use a magic marker that washes off when you thouroughly clean the scanner assembly. 
 -------- 
 !External References 
  
+<?plugin Comment  
 [RaulDeJalapeņo] has written a page about scanner repair which includes lots of pictures: 
 ;: http://www.hammond-tech.com/vibscanref.htm 
 (This link appears to be dead ~~JimCook) 
+?>  
  
-Here is an extracted text version of the scanned pages linked above (may be a bit clearer to read):  
-;: http://www.bentonelectronics.com/vibrato.html  
  
 The following is a very detailed set of instructions and photos that are extremely useful while doing your first [Scanner] rebuild: 
 ;: http://avintagesound.com/REBUILDYOURVIBRATOSCANNER.aspx 
  
+Here is another set of notes, based on a Hammond service note:  
+;: http://www.bentonelectronics.com/vibrato.html  
 ---- 
 TopicRepair 

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.