Differences between version 4 and predecessor to the previous major change of HammondsCanKillYou.

Other diffs: Previous Revision, Previous Author

Newer page: version 4 Last edited on October 12, 2010 11:15 pm. by
Older page: version 3 Last edited on February 15, 2003 8:38 am. by
@@ -1,17 +1,18 @@
 !!!Hammonds Can KILL You! 
  
-Hammond organs, Leslie amplifiers, and other tube equipment typically operate off of power supplies of a few hundred volts. These are potentially ''__lethal voltages__''. (Even 110 volt AC line voltage can ''do you in''.) 
+Hammond organs, Leslie amplifiers, and other tube equipment typically operate off of power supplies of a few hundred volts. These are potentially ''__lethal voltages__''. (Even 110 volt AC line voltage can ''do you in''.)*  
  
 Even after the equipment is turned off and unplugged, electrolytic capacitors 
 can store a __lethal charge__ for a period of minutes to hours. So, please, be very, very careful when poking around inside your Hammond or Leslie. 
  
 If you are not comfortable around electronics, perhaps you should leave such work to a qualified HammondTechnician. 
  
+*Voltage is a measure of potential. Electric potential is the energy required to move a unit electric charge to a particular place in a static electric field; higher voltages mean the electricity can move through more resistance, meaning that it's more likely to be able to jump to/though you from the source. In fact, those who receive a high voltage shock are more responsive to artificial respiration than those who receive a low voltage shock; 110 volt AC line voltage is actually more likely to "do you in" than getting struck by lightning. You wouldn't fly a kite in a thunderstorm, so be careful poking around in your organ. Electric current (measured in amps) between 100 and 200 mA are most likely to be lethal, but as little as 60 mA AC across the heart can be lethal.  
 ------- 
 !You don't have to open them up to get zapped. 
  
 Most [Leslie]s and Hammond ToneCabinets make the ''B+'' supply voltage available on their connector pins (it is required by the older Hammond consoles). There can be ''lethal voltages'' on the B+ pin, ''even after the Leslie has been turned off.'' The pins are ''quite exposed'' both on the Leslie amp chasis, and at the organ end of the Leslie cable. So ''be careful'' when un/plugging and handling your Leslie. 
  
 --------- 
 TopicTroubleshooting 
 TopicRepair 

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.