Differences between version 20 and predecessor to the previous major change of GettingALineOutFromThePhonoJack.

Other diffs: Previous Revision, Previous Author

Newer page: version 20 Last edited on December 21, 2016 11:26 pm. by
Older page: version 19 Last edited on August 3, 2012 12:44 pm. by
@@ -66,4 +66,11 @@
  
  
 ----- 
 TopicHookup 
+  
+  
+12/21/2016  
+  
+I did this today, super easy although my yellow wire was in front, I did not have the cap to gnd. I first cut the car and used clips to test the new cap, worked fine  
+So I soldered it in. Then, on the RT of the lower manual, I replaced the wood panel with a scrap piece of wood the same size, drilled out a few holes and have a zoom mt100 pedals there.  
+I use it for reverb, chorus, detune, flander, delay, echo, etc. I Have this now running into a zoom g3x used only as a preamp, into a carvin dCM 200l, then into a JBL e120. It is very sweet. I am getting a SMS classic preamp which I expect to make this sound even better. Now, I just need to replace my electro caps because the noise still comes through the line out, but then again with the SMS I may just take out the amp. So if anyone can help me find out have to Do This I'd appreciate it. Oh, my M3 is a 1960.  

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.