Differences between version 3 and previous revision of ChangingThePercussionKeyingSource.

Other diffs: Previous Major Revision, Previous Author

Newer page: version 3 Last edited on February 15, 2003 7:14 am. by
Older page: version 2 Last edited on February 14, 2003 8:15 am. by
@@ -20,5 +20,5 @@
 # There are two ''white'' wires soldered to one of the dual-lugs on the ''resistor panel''. This is the left-most lug on my A-100's Resistor Panel. One of the ''white'' wires comes from the Percussion switch and one comes from the ''preset bundle''. Identify and unsolder the ''white'' wire that comes from the ''preset bundle'' (routed from behind the ''preset panel'') that is attached to a dual-lug on the ''resistor panel''. 
 # Solder the ''gray'' wire, removed in step 1, to the ''resistor panel'' at the point where the ''white'' wire was removed in the previous step. 
 # Solder the ''white'' wire, removed from the ''resistor panel'' in step 3, to the 9th drawbar. Splice a short length of wire to it if it's not long enough. 
 ---- 
-HammondModifications  
+TopicModification  

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.